The solution is simple: Get yourself some Deoxit D5. For another thing, if it shuts down only with speakers attached the problem could be outbound at one or more of the speakers. I would isolate that piece somewhat before throwing my hands up and calling Onkyo. Make sure that the speaker cables are not shorting. .
Lately animated manuals and instructional videos are quite popular among customers. First is there an easy way to remedy a short in the volume knob. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. Secondly i could never get the set of B channel speakers to work. Plug back in and turn on without the speakers connected. The receiver may have detected a problem with a speaker or speaker wire. Posted on Apr 17, 2009 Hello, I am sorry about your issue.
Disconnect certain speakers and try it again until you figure out which one s are involved. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects. After a successful purchase of an item one should find a moment and get to know with every part of an instruction. If it does not stay on after the one hour it would need to be serviced. The manuals will serve as an informational aid.
The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. I dont have the user manual and my brother that gave me that amp thought that there was a special set up to get the B speaker outputs to work. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. First step would be to disconnect the speakers, turn the volume control all the way down, then power it up. Eventually, when one still can't find the answer to his problems, he will be directed to the Onkyo service.
When i turn on the amp one speaker usually wont come on until i either turn down the volume or turn up the volume. After that, reconnect the power cord and set the volume to maximum. If it stays on lower the volume and add one speaker. If it stays on turn up the volume to maximum and leave on for ten minutes. This is a spray that will clean out all the oxidation in the volume pot. If the amp is not in Protection mode you should always be able to detect some hiss up close. To do this you'll need to remove the cover of the receiver.
Remove the power cord from the wall outlet immediately. Continue this procedure until all speakers are connected. If so, is it well ventilated and away from other heat sources? Please remove all of the speakers and unplug the receiver for at least an hour. Deoxit can be bought at guitar shops, or if you know a musician they might be willing to do it for you. The receiver has a short protection circuit that keeps you from blowing the receiver or your speakers. Why one should read the manuals? A necessary precondition for this is the unmistakable, legible character of an instruction.
Somewhere in here is the answer. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. Turn on and leave on for several minutes. Usually it results from the lack of time and certainty about functionalities of purchased items. Either try re-cutting the ends of the speaker wire, or if that doesn't remedy the issue, buy new speaker wire. What should a perfect user manual contain? Oct 23, 2010 Does it only happen when its being stressed played really loud? Then it could be the speakers.
Apr 16, 2009 You have a short in the speaker wiring. . . . .