Follow the manufacturer's recommendations for ambient tem- perature operation. Polaris also recommends that you use only Pure Polaris parts. As an off-road enthusiast, you represent the sport and can set a good example or a poor example for others to follow. No single action on your part is as important as following the proce- dures for a proper break-in. Always make sure lights are adjusted properly for best visibility.
To exit the diagnostic mode, turn the key switch off and on. Improper procedure could cause loss of control or overturn. It can also hinder vehicle performance. Operator and passenger must always wear an approved helmet that fits properly and eye protection goggles or face shield. Using an oil filter wrench, turn the filter counter-clockwise to remove it. Maintain the oil level at the bottom of the fill plug hole threads.
Do not dilute with water. The part number is printed on the label. Do not operate on excessively rough, slippery or loose terrain. Always use Polaris-recommended spark plugs. Remove the headlamp and install the new headlamp. It is a potential violation of the Clean Air Act if a part supplied by an aftermarket parts manufacturer reduces the effectiveness of the vehicle's emission controls.
In addition to showing vehicle speed, the speedometer needle flashes when a warning condition exists. Improper procedure could cause loss of control or overturn. The best and safest way to clean your Polaris vehicle is with a garden hose and a pail of mild soap and water. Always change the oil filter whenever changing oil. Follow the battery charging instructions on page 101 before installing the battery.
Always check for obstacles or people behind the vehicle. When removing the battery, always disconnect the negative black cable first. If it's unavoidable, follow these precautions: 1. There will be few combustion deposits. This is an adult vehicle only.
If you discover improper alignment, see your Polaris dealer for ser- vice. Do not use plastic or coated mate- rials. A repair manual is a professional book of instructions that list maintenance, repair and overhaul of the 4-wheeler's main components. Always warm up the belt by operating below 30 mph for one mile 5 miles or more when temperature is below freezing. Tip: The starter interlock will prevent the engine from starting if the transmission is in gear and the brake is not engaged.
Secure the fuel cap, oil cap and seat. Follow the instructions on the container for the recommended amount. The engine will not start or run when the switch is off. Take the vehicle to your dealer before starting the engine. Complete the recommended safety training before operating this vehicle. Reinstall the harness assembly into the headlight assembly.
The electrodes are not burned or eroded. Carbon Clean removes water from fuel systems, stabilizes fuel and removes carbon deposits from pistons, rings, valves and exhaust systems. Water accu- mulation increases as outside temperature decreases. Engine speed returns to idle when the lever is released. Always check for obstacles before operating in a new area. Never back down a hill. Well, silver bolts came out of my engine and I'm going to be replacing them with new bolts, however the parts fiche doesn't specify bolt color or that there is even an option!?! The instrument cluster measures distance in miles as well as hours of operation.
Maintain brake fluid at the recommended level. On conventional batteries, remove the battery vent tube. Torque spark plugs to specification. Using a clean dry cloth, clean the filter sealing surface on the crank- case. It contains important safety information.